20
40
00
32
en
_b
a_
a0
57
Device settings
General settings
The following functions can be toggled
on or off by pressing the Fox key under
x
/
o
.
1.
Select
P m
>
Device
settings
>
Settings
>
Headset
.
In standby mode, the
s
status-
symbol appears for the headset.
2.
Detach the receiver from the base
station and attach the headset to
the connection.
Note:
To answer calls with the headset, press the
loudspeaker key on your telephone or pick
up the telephone receiver. To initiate calls,
first dial the phone number and then press
the loudspeaker key or pick up the tele-
phone receiver. Also be sure to follow the
instructions for the headset.
You end the call by hanging up the receiver
or pressing the loudspeaker key again.
Hands-free operation is not possible when
the headset is active. Open listening is
possible.
Keyclick
If keyclick is switched on, you hear an
acknowledgement tone on the handset
each time a key is pressed.
Message tone
When the message tone is on, a signal tone
(“beep, beep”) sounds whenever an SMS
message arrives.
Device settings
➌
Settings
o
Headset
➋
o
Message Tone
o
Charging beep
1
o
Direct accept
1
o
Backlight
o
Keyclick
o
Range beep
1
o
Autom. DTMF
➊
Only on handset
➋
Only on base station
➌
On handset under “Handset settings”.
Headset (optional)
You can equip your base station with a
headset (ear phone and microphone) in
place of the telephone receiver. The headset
is available in shops. Please make sure that
the equipment is compatible to your Eurit
595
ISDN
.
We recommend a headset from Suprag
(www.suprag.ch).
Please refer to the headset manufacturer’s
instructions for how to connect and operate
this accessory. To operate your telephone
with a headset, proceed as follows:
Содержание Eurit 595
Страница 102: ......
