Swift Motorhomes 2013, Руководство по обслуживанию и гарантии владельца

Страница: 39 / 205

SAFETY AND SECURITY
37
ACTIVATING THE CARBON
MONOXIDE ALARM
See diagram below
Your detector comes complete with an
integrated power pack that will provide
power for its entire operational life. To
activate the power pack you need to pull
the disabling tab (see image). This will in
turn pull out the metal disabling clip, which
is attached to the end of the tab, from
the disabling socket which is situated on
the underside of the detector. Retain the
disabling tab for future use by taping it to
page 20 of the CO-9X user manual.
NORMAL OPERATION OF THE ALARM
When the detector is activated the Power
LED will begin to flash green once every
minute to indicate that the detector is
receiving power from the power pack and is
fully operational.
TESTING THE ALARM
Test the sounder, power pack and circuitry
by pressing and holding the centre of the
Test/Reset button briefly to confirm that
the detector is operating properly. The
sounder will sound as soon as the button is
pressed, and the Alarm LED will illuminate
red indicating that the sounder is working
and the power pack is providing power to
the unit. This test for the sounder, power
pack and circuitry should be performed on a
weekly basis. This should be continued for
the lifetime of the product.
WARNING: Prolonged exposure to the
sounder in close proximity to your ears
may damage your hearing. Under normal
operating conditions, the power pack will
last for the lifetime of the product i.e 7 years.
The detector will not protect against the risk
of carbon monoxide poisoning when the
power pack has drained
SENSOR TESTING.
The alarm manufacturer recommends that
this is carried out monthly. See of the CO-9X
user manual for more details.
CO ALARM OPERATION WHEN CO
DETECTED
The higher the concentration of carbon
monoxide detected by the detector, the
quicker it will respond. When sufficient
carbon monoxide is detected a loud audible
signal (85 dB at 1m (3 feet)) will be emitted
and the Alarm LED will flash red once every
second.
The Alarm will sound:
• Between 60 and 90 minutes when exposed
to a minimum of 50ppm of CO.
• Between 10 and 40 minutes when exposed
to a minimum of 100ppm of CO.
• Within 3 minutes when exposed to a
minimum of 300ppm of CO.
FAULT / LOW POWER PACK SIGNAL:
The unit continuously checks the settings
of its sensor and circuitry. If any of these
settings are found to be incorrect or if the
power pack becomes low then the detector
will emit a single chirp once per minute and
the Fault LED will flash yellow once per
minute for up to 30 days.
IMPORTANT: This does NOT mean that the
detector has detected carbon monoxide.