Swift Motorhomes 2013, Руководство по обслуживанию и гарантии владельца

Страница: 181 / 205

FITTED EQUIPMENT
179
CARE OF LAMINATE TOPS /DROP DOWN TV
MECHANISM / 12V READING LAMP / TV INLET
marked 12v, TV, and SAT. The co-ax from
the external connection point will route to the
socket output marked SAT, whilst the co-ax
from the wardrobe or similar will route to the
socket output marked TV. At any secondary
TV positions, if present, the co-ax from the
wardrobe will route to the socket output
marked TV.
An external TV aerial or site TV feed can be
connected to the external connection point;
signals from that connection will then be
available at the primary TV position within the
motorhome. As the connections are of the
screw-on type, it is also possible to use this
co-ax to route from an externally mounted
satellite dish, to a satellite receiver.
Co-ax connection point within the
mains inlet enclosure, Satellite decoder
position within the motorhome.
(Kon Tiki and E700)
C
M
Y
CM
MY
CY
CMY
K
tv 3.pdf 1 31/05/2011 11:17
A short co-ax lead featuring a screw on co-ax
connection will be present behind the Blue
mains inlet connector. A co-ax cable will be
fitted and connected within the motorhome,
from the back of this connection, to the
location intended for the later fitment of a
satellite decoder or similar receiver. At the
same time, further co-ax cable or cables will
be fitted which route from a likely TV aerial
position (i.e. within the wardrobe) to each of
the TV positions within the motorhome.
The external connection can be used to link a
dish or external aerial, to the decoder / receiver
position, and the co-ax leads from each TV
point can then be used to link the decoder /
receiver to each TV.
Depending on the type of decoder / receiver,
it is possible that a modulator or similar
component would be required to convert the
output from the device (SCART or HDMI) into a
signal that can be sent through co-ax cable.
SHOWER
When using the shower, always ensure that
the shower door is fully closed thus avoiding
water spray on unprotected areas
TRIGGER SHOWER HEADS
• Squeeze trigger to release water. Release
trigger to stop. Twist trigger up to gain
permanent water flow, lower to stop.
• Care should be taken as water may
become hot temporarily when switched on
until it mixes and regulates.
• Small children should be surpervised at all
times when using the shower.
• We recommend unfastening the trigger
shower head before travelling and storing
safely to prevent it becoming detached
whilst travelling.
COLOUR REFERENCE
The colour code for touch ups or resprays for
all white Fiat/Peugeot cabs and Swift coach
built habitational body components is Fiat
White 249. For silver cabs the colour reference
is silver metallic 611. For Fiat/Peugeot cabs
other than white, contact your Fiat/Peuget
dealer or obtain a colour match.
Please be aware that colours can fade over
time, and therefore, if the vehicle is more than
a few years old, it is suggested a colour match
be obtained.