swepac F 82B, Руководство пользователя

Страница: 15 / 28

Doc:
101547
-GB-2140
15
Bergvägen 7 | SE-341 32 Ljungby | Sweden • Tel +46 (0)372-156 00 | www.swepac.com
F82B
F92B
FUNCTION OVERVIEW
The machine consists of a base plate with a vibration
element and an upper part cushioned from the base
plate.
The upper part include even carrying handle.
The power is transmitted from the DC power unit to the
vibration element via a V-belt. For instructions to adjust
the V-belt, see ”SERVICE” on page 18 .
The motor is fitted with an integrated V-belt wheel.
Due to the direction of rotation and the position of the
vibration element at the front end of the base plate, the
vibrator moves forward under its own power.
Work with the machine in daylight or other adequate
lighting. All other use is discouraged.
Common options are the water tank, transport wheels
and a polyurethane pad.
OPERATION
Start
When the applicable maintenance and the steps in PRE-
OPERATION are done the machine can be started.
• Press the START/STOP switch to the STOP position.
• Press the POWER button. All the indicators should
illuminate for a few seconds, and then only the POWER
indicator remains illuminated.
• Press the START/STOP switch to the START position to
start the machine.
– If the POWER button is pressed when the START/STOP
switch is in the START position, the POWER indicator
remains off and the ALERT indicator flashes. In this case,
the machine cannot start. Press the START/STOP switch to
the STOP position and then press the POWER button.
– It may take some time for the indicators to light after the
POWER button is pressed. If the indicators do not light,
press the POWER button again.
– If the machine is not operated for about one minute
after the POWER button is pressed, the POWER indicator
turns off. Press the POWER button again to start the
machine.
Checking the charge level of the battery pack
While the machine is operating, the charge level indicator
lights or flashes so you can confirm the charge level of the
battery pack.
While the machine is stopped, press the charge level
check button to confirm the charge level of the battery
pack.
Indicator display Charge level
High Fully charged.
Sufficiently charged.
Remaining battery
power is low.
Charge the battery
pack.
Low
:On :Flashing :Off
Stop
The machine stops when the START/STOP switch is
pressed to the STOP position. The DC power unit stops
and the POWER indicator turns off.
You can also stop the DC power unit by pressing the
POWER button, but it may take some time to stop.
Removing the battery pack
• Remove the power cable from the battery pack.
• Pull the battery fastener lever down to unlock the
battery pack.
• Tilt the battery pack up and pull the battery pack claw
out from the battery hook.
• Remove the battery pack.
• Attach the battery connector cap to the power cabl e.
CHARGING PROCEDURE
About the power source
Model area Power source
For North America AC 120V
For Europe and Switzerland AC 230V
For United Kingdom AC 240V
For Japan AC 100V
Charging time
Charging time from zero to full charge: about 1.5 hours.
• Charging may take longer when a battery pack is charged
immediately after being used in a specified device. This is
because the battery pack needs to be cooled before it can
charge.
• Charging time for a low-temperature battery pack is
shorter because its capacity to charge is smaller. When
this happens, the time the battery pack can be used is
also shorter.
Precautions
• When you plug the AC plug into the electric outlet, be
sure to plug it all the way in.
• The Battery Charger and AC cable become warm during
charging, but this is not abnormal.
• Charging stops during a power outage.