swepac F 82B, Руководство пользователя

Страница: 22 / 28

Doc:
101547
-GB-2140
22
Bergvägen 7 | SE-341 32 Ljungby | Sweden • Tel +46 (0)372-156 00 | www.swepac.com
F82B
F92B
Battery
Check the indicators and follow the instructions below when there is a malfunction.
If a problem is not resolved or the symptoms do not improve, contact an authorized Dynapac servicing dealer.
ALERT ERROR
B00048
1 2 3
4
1.Charge level check button 2.Charge level indicator 3. ALERT indicator 4. ERROR indicator
Indicator
Possible cause Solution
ALERT ERROR Charge level
Flash —
— Problem was detected.
Remove all equipment connected to the
battery pack, wait for about 5 minutes and
press the Charge level check button.
• When the ALERT indicator does not flash,
the battery pack can be used normally.
4 indicators
flash
Problem was detected.
(Overvoltage protection)
After following the instructions for the
battery pack problem, connect the specified
device and check if it works properly.
• When the device works, the battery pack
can be used normally.
1 indicator
flashes
Problem was detected.
(Low voltage protection)
After following the instructions for the
battery pack problem, connect the battery
charger and check if the charging starts
properly.
• When the charging starts, the battery pack
can be used normally.
—
Illuminate
—
Problem with the
specified device or
battery charger, or
malfunction in the
battery pack was
detected.
Remove all equipment connected to the
battery pack, wait until all indicators turn off
and press the Charge level check button.
• When the ERROR indicator does not
illuminate, the battery pack can be used
normally.
Check that there is no foreign material
around the battery pack. Connect the
specified device or battery charger.
• When the ERROR indicator illuminates,
there is a problem with the specified device
or battery charger.
Flash
Malfunction was
detected.
Battery pack is dead.