swepac F 82B, Руководство пользователя

Страница: 18 / 28

Doc:
101547
-GB-2140
18
Bergvägen 7 | SE-341 32 Ljungby | Sweden • Tel +46 (0)372-156 00 | www.swepac.com
F82B
F92B
Polyurethane pad
B00025
3
1
2
A polyurethane pad is used for stone paving work to
protect against stones and ground clinker.
To mount the polyurethane pad do as follow:
• Place the machine on the polyurethane pad (1).
• Position the bracket (2) so that the screws fits into the
holes on the pad and the base plate.
• Mount and tighten the nuts and washers (3).
SERVICE
Check V-belt drive
Check the tension and condition of the V-belt regularly.
Replace a damaged V-belt with the new type
XPA 907.
Adjust tension, V-belt
B00023
2
1
2
3
4
• Unscrew the screw (1) holding the cover.
• Loosen the two screws (2) holding the cover.
• Remove the cover (3).
• Loosen the four (two on each side) screws (4).
B00024
2
1
3
• Tension the V-belt (1) by pulling the motor (2) towards
the operator side.
• Tighten the four screws.
• Reassembly the cover in the reverse order.
• Check the condition of the four rubber dampers (3)
regularly. Replace damaged dampers.
TRANSPORTATION
It is easy to remove the handle without tools and the boot
of a standard car is sufficient to transport the machine.
Note the following precautions when transporting the
machine.
• Make sure the DC power unit has cooled down.
• Remove the battery pack.
• Keep the machine in level during transportation.
Lifting the machine by hand
Remove the handle by pushing it forward and pull apart
the shafts so that the fastening tabs release.
Move the handle slightly sideways so that the handle
release.
The machine must be lifted by 2 persons.
Lift by means of the handle on the back and the front
edge of the machine.
B00032
1
2
3
Lifting the machine with crane
• Tilt the handle (1) forward.
• Fit a lifting sling (2) around the lifting point (3) and thread
the lifting sling between the shafts of the handle.