3-44 ENGINE
DRIVE SHAFT INSPECTION
Inspect the drive shaft for wear or damage.
If any defects are found, replace it with a new one.
FINAL DRIVEN GEAR AND IDLE GEAR INSPECTION
Inspect the final driven gear
1
and idle gear
2
for wear or dam-
age. If any defects are found, replace the drive shaft gear and
idle gear with new ones.
FINAL REDUCTION GEAR BOX INSPECTION AND DISAS-
SEMBLY
Rotate the bearing inner race by finger to inspect for abnormal
play, noise and smooth rotation while the bearings are in the
those cases.
Replace the bearing in the following procedure if there is any-
thing unusual.
• Remove the bearings with the special tool.
\
09921-20240: Bearing remover set
1
:
¬
12
2
:
¬
17
• Remove the oil seal
3
with the special tool.
\
09913-50121: Oil seal remover
NOTE:
If there is abnormal condition, the oil seal removal is not neces-
sary.
Play
Play
Содержание LT-Z90K7
