6-14 ELECTRICAL SYSTEM
STARTER MOTOR INSPECTION
CARBON BRUSH
• Inspect the brushes for abnormal wear, cracks, or smooth-
ness in the brush holder.
If any defects are found, replace the housing end assembly
with a new one.
• Measure the brush length
A
of the brushes using a vernier
calipers. If measurement is less than the service limit, replace
the housing end assembly with a new one.
\
09900-20101: Vernier calipers
Brush length
Service Limit: 5.0 mm (0.196 in)
COMMUTATOR
Inspect the commutator for discoloration, abnormal wear or
undercut
A
.
If abnormal wear is found, replace the armature with a new one.
If the commutator surface is discolored, polish it with #400 sand
paper and wipe it using a clean dry cloth.
If there is no undercut, scrape out the insulator with a saw blade.
1
Insulator
2
Segment
ARMATURE COIL INSPECTION
Check for continuity between each segment and between each
segment and the armature shaft with the multi-circuit tester.
If there is no continuity between the segments or there is conti-
nuity between the segments and shaft, replace the armature
with a new one.
\
09900-25008: Multi-circuit tester set
=
Tester knob indication: Continuity test (
?
)
Содержание LT-Z90K7
