ELECTRICAL SYSTEM 6-21
IGNITION COIL RESISTANCE
• Disconnect the ignition coil lead wires and spark plug cap,
and remove the ignition coil.
Measure the ignition coil resistance in both the primary and sec-
ondary windings with the multi-circuit tester. If the resistance is
not within the standard range, replace the ignition coil.
\
09900-25008: Multi-circuit tester set
V
Tester knob indication: Resistance (
W
)
Ignition coil resistance
Primary
: 0.1 – 0.7
W
(Terminal – Terminal)
Secondary : 14 – 20 k
W
(Spark plug cap – Terminal)
CKP SENSOR PEAK VOLTAGE
• Remove the seat. (
5-4)
NOTE:
Make sure all of the couplers are connected properly.
• Disconnect the CDI unit coupler
1
.
Measure the CKP sensor peak voltage in the following proce-
dure.
• Connect the multi-circuit tester with the peak volt adaptor as
follows.
CKP sensor:
+
Probe...Brown lead wire
-
Probe...Black/White lead wire or ground
\
09900-25008: Multi-circuit tester set
• Turn the ignition switch to the “ON” position.
• Press the starter button and allow the engine to turn for a few
seconds, and then measure the CKP sensor peak voltage.
Peak volt adaptor
CKP
sensor
W/R Br
Br
B/W
Generator
Generator
coupler
When using the multi-circuit tester and peak volt
adaptor, refer to the appropriate instruction manual.
Содержание LT-Z90K7
