6-10 ELECTRICAL SYSTEM
GENERATOR NO-LOAD PERFORMANCE
• Remove the left footrest mudguard. (
5-5)
• Disconnect the regulator/rectifier coupler
1
.
• Start the engine and keep it running at 2 800 r/min.
• Using the multi-circuit the voltage between W/R wire and
ground.
If the tester reads under the specified value, replace the genera-
tor coil with a new one.
\
09900-25008: Multi-circuit tester set
W
Tester knob indication: Voltage (~)
Generator no-load performance:
20 V and more at 2 800 r/min (When engine is cold)
REGULATOR/RECTIFIER
• Disconnect the regulator/rectifier coupler
1
.
• Remove the regulator/rectifier
2
.
Measure the voltage between the lead wire with the multi-circuit
tester as indicated in the table below. If the voltage is not within
the specified value, replace the regulator/rectifier with a new
one.
\
09900-25008: Multi-circuit tester set
Tester knob indication: Diode test (
>
)
Unit: V
✽
1.4 V and more (tester’s battery voltage)
NOTE:
If the tester reads 1.4 V and below when the tester probes are
not connected, replace its battery.
W/R
W/R
R/W
B/W
Br
+
Probe of tester to:
-
P
rob
e
of
t
e
s
te
r t
o
:
A
B
C
A
✽
✽
B
✽
✽
C
✽
✽
Содержание LT-Z90K7
