9
Align the dot mark on the handlebars with the master
cylinder-to-holder fitting surface. Tighten the master
cylinder mounting bolts to the specified torque.
"
"
"
"
Front brake master cylinder mounting bolt:
10 N·m (1.0 kgf-m)
A: Holder
C: Bolt
B: Bolt
D: Dot mark
A: Bolt
C: Master cylinder
B: Holder
D: Handlebars
Connect the front brake light switch lead wires cou-
pler to the brake light switch.
A: Front brake light switch
B: Lead wire coupler
#
A: Throttle cable
B: Front brake hose
C: Parking brake lever cable
D: Clutch cable
E: Choke cable
F: Left switch wiring harness
G: Front brake switch lead wire
NOTE: To install the holder correctly, first
tighten the bolt
B
B
B
B
of the upper side with speci-
fied torque and then tighten the bolt
C
C
C
C
of the
lower side.
NOTE:
Install the holder in position according to the
mark “UP”.
Make sure that the holder has no clearance at
the upper side as shown.
Check for brake fluid leakage.
The line drawings on pages 37, 38, 39 and 40
show the proper routing of the control cables,
hose and wiring. Refer to them in addition to
following the instructions carefully.
