17
After confirming that the electrolyte has entered the
battery completely, remove the electrolyte containers
from the battery. Wait for around 20 minutes.
Insert the caps into the filler holes, pressing in firmly
so that the top of the each caps does not protrude
above the upper surface of the battery’s top cover.
A: Caps
Using multi circuit tester, measure the battery volt-
age. The tester should indicate more than 12.5–12.6
V (DC) as shown in the Fig. If the battery voltage is
lower than the specification, charge the battery with a
battery charger.
Recharging time:
4.0 A for one hour or 0.9 A for 5–10 hours
After filling the battery electrolyte or charging battery,
install the battery in the vehicle as follows.
NOTE:
If no air bubbles are coming up from a filler
port, tap the bottom of the container two or
three times. Never remove the container from
the battery.
Never use anything except the specified bat-
tery electrolyte.
Once the sealing cap has been installed in the
battery, do not remove the sealing cap.
NOTE:
Initial charging for a new battery is recom-
mended if two years have elapsed since the
date of manufacture.
When attaching the wiring harness battery
leads to the battery terminals, observe the cor-
rect polarity.
NOTE:
The terminal bolts and nuts are attached to the
battery.
