Suzuki Intruder VZR1800, Руководство по обслуживанию, Страница: 151 / 586

ENGINE 3-99
• Position the gaps of the three ring as shown. Before inserting
each piston into the cylinder, check that the gaps are so
located.
C
2nd ring and lower side rail
D
Upper side rail
E
1st ring and spacer
• Apply a small quantity of MOLYBDENUM OIL SOLUTION
onto each piston pins, front and rear.
(
MOLYBDENUM OIL SOLUTION
• Assemble the pistons and conrods, front and rear.
NOTE:
When installing the pistons, front and rear, the indents
A
on the
piston heads must be located to each exhaust side.
• Place a clean rag over the cylinder base so as not to drop the
piston pin circlips into the crankcase.
• Install the piston pin circlips, front and rear.
"
NOTE:
End gap of the circlip should not be aligned with the cutaway in
the piston pin bore.
Front
Rear
Use new piston pin circlips to prevent circlip failure
which will occur with a bend one.
Front
Rear