Suzuki 2005 VL1500K5, Дополнительное руководство по обслуживанию, Страница: 90 / 181

VL1500K5 (’05-MODEL) 89
Is the voltage OK?
6) After repairing the trouble, clear the DTC using SDS tool.
(
!
Page 42)
Step 1 (When indicating C44/P0135:)
1) Remove the seats. (
!
Page 121)
2) Turn the ignition switch OFF.
3) Check the HO2 sensor for loose or poor contacts.
If OK, then measure the HO2 sensor resistance.
4) Disconnect the HO2 sensor coupler and measure the resis-
tance between terminals.
"
HO2 heater resistance: 6.5 – 8.9
Ω
at 23 °C (73.4 °F)
(White – White)
NOTE:
* Temperature of the sensor affects resistance value largely.
* Make sure that the sensor heater is at correct temperature.
#
09900-25008: Multi-circuit tester set
)
Tester knob indication: Resistance (
Ω
)
Is the voltage OK?
5) After repairing the trouble, clear the DTC using SDS tool.
(
!
Page 42)
YES
• W/G wire or B/Br wire open or shorted to
ground, or poor
7
or
D
connection.
• If wire and connection are OK, intermittent trou-
ble or faulty ECM.
• Recheck each terminal and wire harness for
open circuit and poor connection.
• Replace the ECM with a known good one, and
inspect it again.
NO Replace the HO2 sensor with a new one.
ECM coupler (Harness side)
2
1
YES Go to Step 2.
NO Replace the HO2 sensor with a new one.
1
SA
MP
LE