Supero SUPERSERVER 5013G-6, Руководство пользователя

Страница: 99 / 110

Appendix A: BIOS Post Messages
APPENDIX A
A-1
Appendix A
BIOS POST Messages
During the Power-On Self-Test (POST), the BIOS will check for errors. If an error
is found and a correction is needed, the BIOS will activate an alarm or display a
message.
If a message is displayed, it will be accompanied by the following:
PRESS F1 TO CONTINUE, CTRL-ALT-ESC OR DEL TO ENTER SETUP
POST Beep Codes
Currently, there are two kinds of beep codes used in AwardBIOS. One code indicates
that a video error has occurred and that the BIOS cannot initialize the video screen
to display any additional information. This beep code consists of a single long beep
followed by two short beeps. The other code indicates that a Rambus error has
occurred. This beep code consists of a single long beep that sounds repeatedly.
Error Messages
One or more of the following messages may be displayed if the BIOS detects an error
during the POST. This list includes messages for both the ISA and the EISA BIOS.
CMOS BATTERY HAS FAILED
The CMOS battery is no longer functional. It should be replaced.
CMOS CHECKSUM ERROR
The CMOS hecksum is incorrect. This can indicate that CMOS has been corrupted.
This error may have been caused by a weak battery. Check the battery and replace
if necessary.
DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTER
No boot device was found. This could mean that either a boot drive was not detected
or the drive does not contain the proper system boot files. Insert a system disk into
Drive A: and press <Enter>. If you assumed the system would boot from the hard
drive, make sure the controller is inserted correctly and all cables are properly
attached. Also make sure the disk has been formatted as a boot device. Then reboot
the system.