Supero SUPERSERVER 5013G-6, Руководство пользователя

Страница: 22 / 110

2-4
S
UPER
S
ERVER 5013G-6/5013G-i Manual
2-4 Installing the SuperServer 5013G-6/5013G-i into
a Rack
This section provides information on installing the SuperServer 5013G-6/
5013G-i into a rack unit. If the5013G-6/5013G-i has already been mounted
into a rack, you can skip ahead to Sections 2-5 and 2-6. There are a
variety of rack units on the market, which may mean the assembly proce-
dure will differ slightly. The following is a guideline for installing the 5013G-
6/5013G-i into a rack with the rack rails provided with the system. You
should also refer to the installation instructions that came with the rack unit
you are using.
Identifying the Sections of the Rack Rails
You should have received two rack rail assemblies with the SuperServer
5013G-6/5013G-i. Each of these assemblies consist of two sections: an
inner fixed chassis rail that secures to the 5013G-6/5013G-i (A) and an
outer fixed rack rail that secures directly to the rack itself (B). A sliding rail
guide sandwiched between the two should remain attached to the fixed
rack rail (see Figure 2-1). The A and B rails must be detached from each
other to install.
To remove the fixed chassis rail (A), pull it out as far as possible - you
should hear a "click" sound as a locking tab emerges from inside the rail
assembly and locks the inner rail. Then depress the locking tab to pull the
inner rail completely out. Do this for both the left and right side rack rail
assemblies.
Figure 2-1. Identifying the Sections of the Rack Rails
Mounting Holes
A
Locking Tab
B