Supero SUPERSERVER 5013G-6, Руководство пользователя

Страница: 54 / 110

5-16
S
UPER
S
ERVER 5013G-6/5013G-i Manual
Wake-On-Ring
The Wake-On-Ring header is desig-
nated JWOR. This function allows
y o u r c o m p u t e r t o r e c e i v e a n d b e
"awakened" by an incoming call when
in the suspend state. See the table on
the right for pin definitions. You must
also have a WOR card and cable to
use WOR.
Pin
Number
1
2
Definition
Ground
W ake-up
W ake-On-Ring Pin Definitions
(JW OR1)
5-9 Jumper Settings
Explanation of
Jumpers
To modify the operation of the
motherboard, jumpers can be used
to choose between optional set-
tings. Jumpers create shorts be-
t w e e n t w o p i n s t o c h a n g e t h e
function of the connector. Pin 1 is
identified with a square solder pad
on the printed circuit board. See
the motherboard layout pages for
jumper locations.
Connector
Pins
Jumper
Cap
Setting
Pin 1-2 short
3 2 1
3 2 1
CMOS Clear
JBT1 is used to clear CMOS (which will also clear any passwords). In-
stead of pins, this jumper consists of contact pads to prevent accidentally
clearing the contents of CMOS. Do not use the PW_ON connector to clear
CMOS. To clear CMOS,
1) First power down the system and unplug the power cord(s).
2) With the power disconnected, short the CMOS pads with a metal object
such as a small screwdriver.
3) Remove the screwdriver (or shorting device).
4) Reconnect the power cord(s) and power on the system.
Note: On a two-pin jumper, "Closed" means the jumper is
on both pins and "Open" means the jumper is either on
only one pin or completely removed.