Supero SUPER P6DBE, Руководство пользователя

Страница: 57 / 104

3-2
SUPER P6DBS/P6DBE/P6DBU/P6SBU/P6SBS/P6SBA
Manual
No Power
1. Make sure the default jumper is on and the CPU is correctly set up.
2. Turn power switch on and off to test system.
3. If power is still not on, turn off system power to move jumper setting on
JP20 from 2-3 to 1-2.
4. If moving the jumper setting has not helped, clear CMOS.
5. Check the power supply voltage monitor. (Check the power supply
115V/230V switch)
No Video
Use the following steps for troubleshooting your system configuration.
1. If the power is on but you have no video, remove all the add-in cards and
cables.
2. Check for shorted connections, especially under the motherboard.
3. Check the jumpers settings, clock speed, and voltage settings.
4. Use the speaker to determine if any beep codes exist. Refer to
Appendix A for details about beep codes.
NOTE
If you are a system integrator, VAR or OEM, a POST diagnostics
card is recommended. For port 80h codes, refer to Appendix B.
Memory Errors
If you encounter a memory error, follow the procedures below.
1. Check to determine if DIM modules are improperly installed.
2. Make sure that different types of DIMMs have not been installed in
different banks (e.g., a mixture of 2MB x 36 and 1 MB x 36 DIMMs in
Bank 0).
3. Determine if different speeds of DIMMs have been installed and verify
that the BIOS setup is configured for the fastest speed of RAM used. It
is recommended to use the same RAM speed for DIMMs in the system.
4. Check for bad DIM modules or chips.
5. Try to install the minimum amount of memory first (a single bank).