Supero SUPER P6DBE, Руководство пользователя

Страница: 51 / 104

Chapter 2: Installation
2-13
Top View of DIMM Socket
Figure 2-7. Installing the DIMM
To Install:
Insert
vertically,
press down
until it snaps
into place.
Pay attention
to the two
notches.
To Remove:
Use your thumb to
gently push the
edge of the socket
and release the
module. Do this on
both sides for each
module.
Note: Notches
should align
with the
receptive points
on the socket
D I M M S o c k e t
Side View of DIMM Installation into Socket
DIMM
P C 1 0 0
Notches
P C 1 0 0
Notches
2-10 Connecting Parallel, Floppy and Hard Disk Drives
Use the following information to connect the floppy and hard disk drive
cables.
• The floppy disk drive cable has seven twisted wires.
• A red mark on a wire typically designates the location of pin 1.
• A single floppy disk drive ribbon cable has 34 wires and two connectors
to provide for two floppy disk drives. The connector with twisted wires
always connects to drive A, and the connector that does not have the
twisted wires always connects to drive B.
• An IDE hard disk drive requires a data ribbon cable with 40 wires, and a
SCSI hard disk drive requires a SCSI ribbon cable with 50 wires. A wide
SCSI hard disk drive requires a SCSI ribbon cable with 68 wires.
• A single IDE hard disk drive cable has two connectors to provide for two
drives. To select an IDE disk drive as C, you would normally set the
drive select jumper on the drive to DS1 (or Master). To select an IDE disk
drive as D, you would normally set the drive select jumper on the drive to
DS2 (or Slave). Consult the documentation that came with your disk
drive for details on actual jumper locations and settings.
• A single SCSI ribbon cable typically has three connectors to provide for