Supero SUPER P6DBE, Руководство пользователя

Страница: 43 / 104

Chapter 2: Installation
2-5
When removing the Pentium II processor, avoid pressing
down on the motherboard or components. Instead, press
down on the plastic connectors.
!
2-3 Installation of the Universal Retention Mechanism
(URM)*
Please Note! Screws and washers attach from the bottom of the board
and must be installed before mounting the board to the chassis. (See
Figures 2-5 and 2-6.)
1. When installing the URM, be sure
Left
(L) and
Right
(R) sides are
placed accordingly.
2. Lift both arms upright and slide the processor into the socket, noting
that the notches need to line up.
*These directions may not apply to second source URMs
2-4 Special Instructions for the Celeron Processor
Please Note! The Celeron Processor requires special caps to hold it in
place (these caps are bundled with the motherboard). (See Figures 2-5
and 2-6.)
1. Lift both URM arms to an upright position.
2. Slide the Celeron processor into the socket, noting that the notches
need to line up.
3. Slide the special Celeron caps over the ends of the retention arms.
Make sure the arrows face outward and that the Left (L) and Right (R) caps
are on the appropriate sides of the URM. The caps should snap into place.
4. To remove the caps, pull out on the tab (arrows points to tab), then pull
up.