Supermicro SUPERSERVER 8016B-TLF, Руководство пользователя

Страница: 43 / 108

Chapter 5: Advanced Serverboard Setup
5-11
RDIMM Support
DIMM Slots
per DDR
Channel
DIMMs
Populated
per DDR
Channel
RDIMM Type
(RDIMM: Reg.=
Registered)
POR Speeds (in
MHz)
Ranks per DIMM
(Any Combination)
1 1 Reg. ECC DDR3 800,978, 1066 SR, DR, or QR
2 1 Reg. ECC DDR3 800,978, 1066 SR, DR, or QR
2 2 Reg. ECC DDR3 800,978, 1066 Mixing SR, DR, QR
Population Rules:
1. Any combination of x4 and x8 RDIMMs with 1 Gb or 2 Gb DRAM density are supported.
2. Populate DIMMs starting with DIMM1A.
3. When mixing QR with SR or DR on the same DDR channel, put the QR in DIMM1A fi rst.
Notes and Restrictions
Only DDR3-1066 RDIMMs are validated at speeds of 800, 978, 1066 MHz.
•
For the memory modules to work properly, please install DIMM modules in pairs
•
(with an even number of DIMMs installed).
All channels in a system will run at the fastest common frequency.
•
5-7 Adding PCI-E Add-On Cards
The 8016B-TLF can accommodate one PCI-Express 2.0 x16 card with the use of
the CSE-RR1U-E16 riser card inserted into the PCI-E x16 slot.
Installing an Add-on Card
Begin by removing the PCI slot shield for the slot you wish to populate. 1.
Fully seat the card into the riser card slot, pushing down with your thumbs 2.
evenly on both sides of the card.
Finish by using a screw to secure the top of the card shield to the chassis. 3.
The PCI slot shields protect the serverboard and its components from EMI
and aid in proper ventilation, so make sure there is always a shield covering
each unused slot.