Supermicro SUPERSERVER 8016B-TLF, Руководство пользователя

Страница: 87 / 108

Chapter 7: BIOS
7-17
Select UDMA6 to allow BIOS to use Ultra DMA mode 6. It has a data transfer
rate of 133 MB/s. The options are Auto , SWDMAn, MWDMAn, and UDMAn.
S.M.A.R.T. For Hard disk drives
Self-Monitoring Analysis and Reporting Technology (SMART) can help predict
impending hard disk drive failures. Select Auto to allow AMI BIOS to automati-
cally detect hard disk drive support. Select Disabled to prevent AMI BIOS from
using the S.M.A.R.T. Select Enabled to allow AMI BIOS to use the S.M.A.R.T. to
support hard drive disk. The options are Disabled, Enabled and Auto .
32Bit Data Transfer
Select Enabled to support 32-bit IDE data transfer. The options are Enabled
and Disabled.
Hard Disk Write Protect
Select Enabled to support Hard Disk Write Protect to prevent data from being written
to a hard drive. The options are Enabled or Disabled .
IDE Detect Timeout (sec)
Use this feature to set the timeout value to allow BIOS to detect the ATA, ATAPI
devices installed in the system. The options are 0 (sec), 5, 10, 15, 20, 25, 30, and
35 .
X
PCI/PnP Confi guration
Clear NVRAM
Select Yes to clear Non-Volatile Random Access (Flash) Memory (NVRAM) during
system boot. The options are No and Yes.
Plug & Play OS
Select Yes to allow the OS to confi gure Plug & Play devices. (This is not required
for system boot if your system has an OS that supports Plug & Play.) Select No to
allow AMI BIOS to confi gure all devices in the system.
PCI Latency Timer
This feature sets the PCI Latency Timer for each PCI device installed on a PCI bus.
Select 64 to set the PCI Latency Timer to 64 PCI clock cycles. The options are 32,
64 , 96, 128, 160, 192, 224 and 248.
Palette Snooping
Select Enabled to allow BIOS to inform PCI-E devices that an ISA graphics device
is installed in the system so that the ISA graphics card can function properly. The
options are Disabled and Enabled.