Supermicro SUPERSERVER 8016B-TLF, Руководство пользователя

Страница: 53 / 108

Chapter 5: Advanced Serverboard Setup
5-21
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
GLAN1/2 Enable/Disable
Change the setting of jumper JPL1 to
enable or disable the GLAN1/GLAN2
Ethernets port on the serverboard. The
default setting is enabled. See the table
on the right for jumper settings.
GLAN1/2 Enable/Disable
Jumper Settings (JPL1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog Enable/Disable
JWD controls the Watch Dog function.
Watch Dog is a system monitor that
can reboot the system when a soft-
ware application hangs. Jumping pins
1-2 (the default setting) will cause WD
to reset the system if an application
hangs. Jumping pins 2-3 will generate
a non-maskable interrupt signal for the
application that hangs. See the table on
the right for jumper settings. Watch Dog
must also be enabled in BIOS.
Note: When enabled, the user needs to
write their own application software in
order to disable the Watch Dog Timer.
Watch Dog
Jumper Settings (JWD)
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
TPM Support Enable/Disable
Jumper JPT1 is used to enable TPM
(Trusted Platform Module) support to en-
hance data integrity and system security.
See the table on the right for jumper set-
tings. The default setting is enabled.
TPM Support Enable/Disable
Jumper Settings
Jumper Setting Defi nition
1-2 Enabled
2-3 Disabled