Supermicro SUPERSERVER 6014A-8, Руководство пользователя

Страница: 54 / 130

5-18
S
UPER
S
ERVER 6014A-8 Manual
5-9 Jumper Settings
Explanation of
Jumpers
To modify the operation of the
serverboard, jumpers can be
u s e d t o c h o o s e b e t w e e n
o p t i o n a l s e t t i n g s . J u m p e r s
create shorts between two pins
to change the function of the
connector. Pin 1 is identified
w i t h a s q u a r e s o l d e r p a d o n
the printed circuit board. See
the serverboard layout pages
for jumper locations.
N o t e : O n t w o p i n j u m p e r s ,
"Closed" means the jumper is on
and "Open" means the jumper is
off the pins.
Connector
Pins
Jumper
Cap
Setting
Pin 1-2 short
3 2 1
3 2 1
CMOS Clear
JBT1 is used to clear CMOS (which will also clear any passwords). In-
stead of pins, this jumper consists of contact pads to prevent accidentally
clearing the contents of CMOS.
To clear CMOS,
1) First power down the system and unplug the power cord(s)
2) With the power disconnected, short the CMOS pads with a metal object
such as a small screwdriver
3) Remove the screwdriver (or shorting device)
4) Reconnect the power cord(s) and power on the system.
Note: Do not use the PW_ON connector to clear CMOS.
VGA Enable/Disable
JPG1 enables or disables the VGA
port. See the table on the right for
jumper settings (the default setting
is enabled).
Jumper
Position
Pins 1-2
Pins 2-3
Definition
Enabled
Disabled
VGA
Enable/Disable
Jumper Settings
(JPG1)