Supermicro SUPERSERVER 6014A-8, Руководство пользователя

Страница: 43 / 130

Chapter 5: Advanced Serverboard Setup
5-7
5-4 I/O Ports
The I/O ports are color coded in conformance with the PC 99 specification.
See Figure 5-4 below for the colors and locations of the various I/O ports.
Figure 5-4. I/O Ports
5-5 Installing Memory
Note: Check the Supermicro web site for recommended memory modules:
http://www.supermicro.com/support/resources/
CAUTION
Exercise extreme care when installing or removing DIMM modules
to prevent any possible damage. Also note that the memory is
interleaved to improve performance (see step 1).
DIMM Installation (Figures 5-5a and 5-5b)
1. Insert the desired number of DIMMs into the memory slots, starting with
Bank #1A. The memory scheme is interleaved so you must install two
modules at a time, beginning with DIMM #1A, then DIMM #1B, and so on.
2. Insert each DIMM module vertically into its slot. Pay attention to the
notch along the bottom of the module to prevent inserting the DIMM
module incorrectly.
3. Gently press down on the DIMM module until it snaps into place in the
slot. Repeat for all modules (see step 1 above).
Memory Support
The X6DAR-8G supports up to 32/16 GB of registered DDR266/333 (PC2100/
2700) SDRAM (recommended by the manufacturer). This serverboard was
designed to support 2 GB modules in each slot, but has only been verified
for up to 1 GB modules. The memory is an interleaved configuration, which
COM1 GLAN1/2 Mouse USB0/1
VGA Port
Keyboard
SCSI Port