Supermicro SUPERSERVER 6014A-8, Руководство пользователя

Страница: 53 / 130

Chapter 5: Advanced Serverboard Setup
5-17
Power Fault
Connect a cable from your power
supply to the Power Fail header
(JP9) to provide warning of power
supply failure. This warning sig-
n a l i s p a s s e d t h r o u g h t h e
PWR_LED pin to indicate of a
power failure on the chassis. See
the table on the right for pin defini-
tions.
Power Fail
Pin Definitions (JP9)
Pin
Number
1
2
3
4
Definition
P/S 1 Fail Signal
P/S 2 Fail Signal
P/S 3 Fail Signal
Reset (from MB)
Note: This feature is only available when
using redundant Supermicro power supplies.
Overheat LED (JOH1)
C o n n e c t a n L E D t o t h e J O H 1
h e a d e r t o p r o v i d e w a r n i n g o f
c h a s s i s o v e r h e a t i n g . S e e t h e
table on the right for pin defini-
tions.
Pin
Number
1
2
Definition
+5V
OH Active
Overheat LED
Pin Definitions (JOH1)
Alarm Reset
The system will notify you in the
event of a power supply failure.
This feature assumes that Super-
m i c r o r e d u n d a n t p o w e r s u p p l y
units are installed in the chassis.
Connect a microswitch to JP11 to
enable you to turn off the alarm
that sounds when a power supply
module fails. See the table on the
right for pin definitions.
Jumper
Position
Open
Short
Definition
Normal(*default)
Clear Alarm
Alarm Reset
(JP11)
SMB Power Connector
Connect the SMB power connec-
tor to J32 (located near DIMM slot
#1A) to utilize SMB.
SMB PWR
Pin Definitions (J32)
Pin #
1
2
3
4
5
Definition
Clock
Data
N/A
N/A
N/A