Supermicro FatTwin F628G3-FT+, Руководство пользователя

Страница: 63 / 160

Chapter 5: Advanced Serverboard Setup
5-9
5-5 Installing Memory
Caution: exercise extreme care when installing or removing DIMM modules to prevent
any possible damage.
Installing Memory
1. Insert the desired number of DIMMs into the memory slots, starting with
P1-DIMM #A1. (For best performance, please use the memory modules of the
same type and speed in the same bank.)
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
5. Use two thumbs together to press on both ends of the module straight down
into the slot until the module snaps into place.
6. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
Reverse the steps above to remove the DIMM modules from the serverboard.
Note: 4 GB, 8 GB, 16 GB or 32 GB size memory modules are supported. It is
highly recommended that you remove the power cord from the system before
installing or changing memory modules. Please refer to our web site for memory
that has been tested on the X10DRFF-iG/iTG serverboard.
Figure 5-2. Installing DIMM into Slot
Release Tabs
Notches
Press both notches straight down into
the memory slot at the same time.
Removing Memory Modules
Press the release tabs on both ends of the memory module to unlock it. Once it is
loosened, remove the DIMM module from the memory slot.