20
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Step 5. REMOVE ThE GLASS DOOR
ASSEMBLY
Refer to
Figure 40 on Page 24
and remove the
front glass door assembly as follows:
To remove the firescreens, lift up the center of
the rod to disengage it from the center bracket,
bend down at center, hold left side with hand
until it disengages from left side, being careful
not to scratch the paint. Slowly remove the rod
from the right side.
Using a Phillips screwdriver, unfasten the two
(2) screws located at the top of the glass door
assembly.
Tilt the glass door assembly at the top away
from the unit. Lift it carefully off the bottom
door track and set the glass door assembly
aside, protecting it from inadvertent damage.
WARNING
•
handle this glass with extreme
care! Glass is susceptible to
damage - Do not scratch or
handle roughly.
•
Do not attempt to substitute the
materials used on this door,
or replace cracked or broken
glass with any materials other
than those provided by the
appliance manufacturer.
•
The glass door of this appliance
must only be replaced as a
complete unit as provided
by the manufacturer. Do not
attempt to replace broken,
cracked, or chipped glass
separately.
INNOVATIVE HEARTH PRODUCTS • POWER VENT DV GAS FIREPLACES (DRT63__TYN / DRC63__TYN) • INSTALLATION INSTRUCTIONS
Factory Wired
Field Wired
Junction Box
Tab Intact
Tab
Intact
n e
e r
G -
d n
u o r
G
e t i
h
W - l
a r t
u e
N 120 VAC - Black
Green
Ground
Screw
Whit
e
Gree
n
Neutral
Side
Hot
Side
Red
Black
Figure 28 - Junction Box Wiring -
120 V, 60 hz, 1-phase
Figure 27 - Electronic Wiring Diagram
580489-01
Pilot Tube
Spark
Electrode
Flame
Sensor
IPI Pilot
885 Valve
Optional
Split Flow
BL
W
Y
Y
BR
G
O
O
R
R
B
B
G
GR
R
B
BL
WH
B
B
W
G
Battery Holder w/Switch
ON/ Remote
/OFF
Battery Holder
Wire Harness
Reset Switch
(See instructions.)
Power Vent Blower
Power Vent
Models Only
Air Pressure Switch
Power Vent Only
Note: On models
without pressure
switch, these
connectors are
plugged together.
Main Wire
Harness
Main Power Cord
Control Module
G
B
G
W
B
Fuse
ELECTRONIC WIRING DIAGRAM
Ground Y
B
Battery Holder with Switch
ON/Remote/OFF
(Schematic representation only)
COLOR CODE:
B = Black
BB = Brown w/Black Stripe
BG = Brown w/Green Stripe
BL = Blue
BR = Brown
G = Green
GY = Gray
O = Orange
R = Red
W = White
Y = Yellow
