Shenzhen SUNSKY Technology Limited
15
If you need detail instruction, send following SMS command to camera:
For master and families
：
#09#1#
For guest
：
#09#password#1#
10. Reset the camera
This function reset all settings to their original values, it will clean all setting including. The
setting values of master number, remote control, and wireless sensor will be erased too so
you need to use this function carefully.
Method 1:Switch off the remote camera(push the switch to bottom side) for more than 20
seconds. Press and hold the setting key at the rear board of the camera and then switch on
the camera again. The indicator will lighten green constantly for 2-4 seconds and turn to flash
red slowly. A “DI” tone can be heard from the camera indicated the successful reset operation.
Method 2
：
Master sends following SMS command to camera:
#08#password#
It will reply “The GSM camera have successfully reset to its default settings”.
Note:
1. The password is needed with the SMS command, othetwise, a SMS “You forgot
including 4 digit password to reset camera” will be sent and the operation is rejected.
2. Only master can make this operation, otherwise, it will reply SMS “Sorry, you are
prohibited to request this command”.
3. After resetting, the camera is needed to restart. Activating the remote control and
loading the wireless sensor are needed too. Read “Chapter 4. Quick Start, 2. Start
remote camera” operation for detail information.
4. The MMS center number is often stored to the camera. After reset the camera to
default setting, you don’t need to reset the MMS parameter. But if the MMS still can’t
work, you need to reset the MMS parameter, pls refer Chapter 5. 18 Network MMS
parameter setting.
Chapter 5. Advanced Operation
1. Activate remote camera
(Authority: Master)
