Shenzhen SUNSKY Technology Limited
11
Red &
Green
Two color lights
alternately
Loading sensor
Note: Slow flash 1 time per second, quick flash 2 times per second.
Installation
1
、
Install the SIM card
Remove the rubber cover from the left side of host.Open the SIM card slot by pressing the
small dot beside the SIM card slot with the tip of a pencil, and pop-up the slot. Insert the SIM
card into the slot then push the slot back to its place, get back the rubber cover.
Note: This camera only supports GSM network, The Calling line presentation and MMS
function of the SIM card must be activated. Contact your SIM card provider for more
information about the SIM card additional services.
2
、
Extend host base board
Hold the base of the host and pull the head of the camera far away the base direction and the
slot buckle will be indrawn.
The head of the camera now can be located at any direction.
3
、
Connect external Power
Connect the adapter to an AC power, and connect the mini-USB plug to the power interface of
the host.(See Figure 1 Host Instruction,7)
The product has a built-in rechargeable Lithium battery. The camera will notify you when the
power supply switch. For example, if the power adapter is disconnected or the AC power is
failure, it will notify you “External power cut off, supply by battery now”.If the power adapter is
connected again or the AC power is available, it will notify you ”Remote camera resume to
external power now”.
4
、
Mount the host
The host can bo mounted vertically on the wall with the screws or located horizontally at
suitable place.
Choose the Installing place:
For better image quality, avoid the bright light irradiated directly into the lens of the
camera. It is suggested that the camera is located at the place where can look down
the monitoring place with the minimum angel 30
°
.
To prevent to be stolen, it is suggested that the camera is located at the place above
the ground more than 2.2 meters.
