Sun Oracle 4540 - Phaser Copystation, Руководство по обслуживанию, Страница: 189 / 264

Chapter 3 Maintaining the Sun Fire X4500 and X4540 Servers 3-69
Note – This component is a FRU and must be replaced only by qualified service
technicians. Contact your Sun Service representative for assistance.
TABLE 3-20
lists the qualified part numbers for this component. These part numbers
are subject to change over time. For an updated list of components, see the following
web site:
http://sunsolve.sun.com/handbook_pub/Systems/
1. Remove the cable management assembly if necessary.
See one of the following docs depending on your CMA version:
■
Sun Fire X4500/X4540 Installation Guide
■
Sun X4500-J Slide Rail Installation Guide (X4500)
■
“Early-Production Slide Rail and CMA Information” on page G-1 (X4500)
2. Remove the old system controller.
See “To Remove the System Controller (CRU)” on page 3-70 .
3. Move components to new system controller:
If the DIMMs, CPUs, heat sinks, optional PCI cards, and GRASP board (X4500) are
operational and need to be moved to your new system controller, remove them
from the old system controller:
a. See “To Remove Memory Modules (DIMMs) (CRU)” on page 3-61 and “To
Install Memory Modules (DIMMs) (CRU)” on page 3-64 .
b. See “To Replace a CPU (FRU)” on page 3-49 .
c. See “To Replace the GRASP Board (X4500) (FRU)” on page 3-58 .
d. See
“To Install a PCI-X or PCIe Card (FRU)” on page 3-65
4. Reinstall the new system controller into the chassis.
See “Replacing the System Controller (FRU)” on page 3-68 .
TABLE 3-20
Sun Fire X4540 Supported System Controller Part Numbers
Component Part Number
System Controller Upgrade Kit (includes I/O controller board
(USB) and CPU board, 2x2356, 16x2GB (1GB), and document) B24-FSZ2-4540-CONT
(X-option)
System Controller Upgrade Kit (includes I/O controller board
(USB) and CPU board, 2x2435, 16x2GB (1GB), and document) B24-BZ2-4540-CONT
(X-option)