Sun Oracle 4540 - Phaser Copystation, Руководство по обслуживанию, Страница: 116 / 264

2-82 Sun Fire X4500/X4540 Server Service Manual • May 2010
8. Replace the cable management arm as described in one of the following:
■
Sun Cable Management Assembly Installation Guide for the Sun Fire X4540 Server
■
Sun X4500-J Slide Rail Installation Guide (X4500)
■
“Early-Production Slide Rail and CMA Information” on page G-1 (X4500)
9. Replace the system controller as described in “Replacing the System Controller
(FRU)” on page 3-68 .
10. Reconnect AC power cords to the server.
The server enters standby power mode, indicated when the Power/OK LED on
the front panel is flashing.
11. Return the server to main power mode by using a ballpoint pen or other
nonconducting stylus to press and release the recessed Power button on the
front panel.
Note – The password reset is not complete until the entire server reboots, not just
the SP. This is because the state of the P20 jumper cannot be determined until the
host CPU is running. Wait until the end of POST, when you see the
CMOS password
cleared by jumper
message, after which both the BIOS and SP passwords are
reset.
■
The ILOM SP password is reset to the default,
changeme
.
■
The BIOS password is also reset by a separate operation performed by the BIOS
when it discovers the presence of the P20 jumper. The BIOS password is not
reset to
changeme
; it is removed so that there is no longer a BIOS password set.
If you had a BIOS password set, you are no longer prompted for one.
12. Log in to the ILOM web GUI using
root
as the user name and
changeme
as the
password.
For login instructions, refer to the Integrated Lights Out Manager Administration
Guide .
13. Change the default password to a password of your choice.
14. Repeat Step 1 through Step 9 to remove the jumper. (Remove the jumper in
Step n instead of inserting it.)
Note – If you do not remove the passwd clr jumper, the ILOM SP and BIOS
passwords will reset every time you power-cycle the server.