Sun Microsystems StorEdge 3000 Series, Руководство по установке

Страница: 86 / 96

6-12 Sun StorEdge 3000 Family FRU Installation Guide • May 2004
To configure the array, refer to the installation manual for your array, located on
your Sun StorEdge 3000 Family Documentation CD.
To replace the chassis frame of an existing RAID array or expansion unit, perform
the following steps.
1. Connect to the firmware application via the serial interface (tip for Solaris/Linux)
or via telnet.
Caution –
Connected hosts must be inactive during this replacement procedure.
2. If the defective array is a RAID array:
From the Main Menu, choose “view and edit Configuration parameters,” then
choose “Controller Parameters.”
Write down the Controller Unique Identifier (hex) - value.
3. Power off both power supply modules on the defective array.
4. Ensure all SCSI cables attached to the I/O module are labeled clearly.
5. Write down the defective array's cabling configuration.
6. Remove all SCSI cables attached to the I/O module.
7. If the defective array is a RAID array, remove all serial and Ethernet cables
connected to the RAID controllers.
8. Label each disk drive with its disk slot position in the array.
9. Remove the RAID controllers (if applicable), terminator board (if applicable), I/O
module(s), EMUs, power supply modules, and disk drives from the defective
array.
10. Remove the defective chassis.
11. Obtain the replacement chassis.
12. Re-install all previously removed modules in their original positions in the
replacement array.
13. Reinstall all SCSI, serial, Ethernet, and power cables in their original positions.
14. Power on both power supply modules on the replacement array.
15. If the replacement array is an expansion unit or JBOD, refer to your installation
manual to configure it.
16. If the replacement chassis is a RAID array, proceed with the following steps: