Sun Microsystems Netra CT 820, Руководство по обслуживанию

Страница: 59 / 132

Chapter 5 Removing and Replacing Hot-Swappable Cards 5-13
FIGURE 5-5
Location of the Hot-Swap LED on the Netra CP2300 Board
2. Unscrew any retention screws that fasten the board to the enclosure.
If the board occupies multiple slots, unscrew the retention screws in each occupied
slot.
3. Open the ejectors fully, rotating the handles outward until the board disengages
from the midplane (
FIGURE 5-1
).
4. Slide the board evenly out of the enclosure.
5. Determine if you are going to replace the rear transition card or not.
■
If you are going to replace the rear transition card, go to “Removing a Rear
Transition Card for a Node Board” on page 5 14 .
■
If you are not going to replace the rear transition card, install a replacement node
board or a filler panel to maintain the enclosure's shielding and cooling
performance. Refer to
“Installing a Node Board” on page 5 16 .
Hot-swap LED