Sun Microsystems Netra CT 820, Руководство по обслуживанию

Страница: 37 / 132

Chapter 4 Troubleshooting the System 4-7
■
To display a list of options for the
dmcdiag
utility for the standby (1B) DMC, enter
the following command:
The following output will appear:
TABLE 4-1
describes each option available for the
dmcdiag
utility on the active and,
in most cases, the standby DMC. Note that you must enter a comma after the
variable for each option when entering the information in the command line
interface using the
dmcdiag
utility. All test options with enable/disable variables
are set to enabled by default, except for the Power Supply On/Off test.
netract (Standby) cli> dmcdiag -u
dmcdiag options:
[enet=E|D][,epattype=Seq+Rand][,epkts=NUMERIC|1,5][,target=[IP Addr]]
[,etest=IEPing+Phy][,flash=E|D][,aport=E|D]
[,anum=0+1+2+3][,a0on=On|Off|Toggle][,a1on=On|Off|Toggle]
[,a2on=On|Off|Toggle][,a3on=On|Off|Toggle][,health=E|D][,ipmi=E|D]
[,rtc=E|D][,fruidchksum=E|D]
TABLE 4-1
Options for the
dmcdiag
Utility for the Active DMC
Supported on DMC Options Variables Additional Information
Active and
standby
enet=
E
(Enable) Ethernet test. Enter either Enable or Disable.
Refer to “Ethernet Test” on page 4 2 for more
information.
D
(Disable)
Active and
standby
epattype= Seq
(Sequential) Ethernet data pattern type. Enter Sequential
and/or Random. Use the + sign between the two
variables to choose both. Refer to “Ethernet
Test” on page 4 2 for more information.
Rand
(Random)
Active and
standby
epkts= 1 - 5
Number of packets. Enter a number between 1
and 5. Refer to
“Ethernet Test” on page 4 2 for
more information.
Active and
standby
target=
Internet protocol
address Target Internet protocol address. Enter the
target IP address. Refer to
“Ethernet Test” on
page 4 2 for more information.
Active and
standby
etest= Internal
Ethernet test type. Enter Internal and/or
External and/or Ping and/or Phy. Refer to
“Ethernet Test” on page 4 2 for more
information.
External
Ping
Phy