Sun Microsystems Fire X4800, Руководство по установке

Страница: 72 / 142

“How to Insert the Server Into the Rack” on page 72
▼
How to Insert the Server Into the Rack
The following procedure explains how to insert the server into the rack and on to the shelf rail
assemblies in the rack.
Perform the steps in “How to Install the Rack Mounting Hardware in a Round-Hole Rack” on
page 64 .
Lift the server to its position in the rack.
The use of a mechanical lift is recommended.
Caution –
The server weighs 180 pounds (82 kg). To reduce the risk of serious personal injury or
equipment damage, use a mechanical lift to install the server into the rack. If a lift is not
available, remove components as instructed in
“How to Remove Components to Reduce
Weight” on page 49 and use two persons to lift the server into place.
Slide the server onto the shelf rails.
Caution –
Drop Hazard! Do not release the server until the rear of the server is more than 6 inches
(152 mm) into the rack, and is firmly supported by the shelf rails. The shelf rails will not support
the server until it is
more than 6 inches (152 mm) inside the rack.
Note –
If the server is still on a pallet, you can leave it on the pallet and lift both the server and the
pallet with the mechanical lift, and slide the server off the pallet and onto the shelf rails.
Next Steps
Before You Begin
1
2
Installing the Server in a Rack Using the Universal Rack Mounting Kit
Sun Fire X4800 Server Installation Guide • —12, March 2011 72