Sun Microsystems Cobalt LX50, Руководство пользователя

Страница: 45 / 138

Installing the Server Using the Slide Rail Kit (Optional)
User Guide—Sun Cobalt LX50 Server 2-23
Attach Rail Brackets to Posts
1. Using two screws (Figure 23, A) with washers, attach one nut bar (B) to the inside of the rack post. Do not
completely tighten the screws—leave them loose enough to allow insertion of the brackets in the next step.
2. Insert the slotted foot of a rail bracket between each nut bar and post.
3. Align the face of the bracket foot with the inside edge of the rack post and firmly tighten the screws.
4. Repeat steps 1 to 3 above to install the other 3 brackets (2 Front and 2 Back total). Ensure all brackets are at the
same height on the rack.
Figure 23. Attaching a Rail Bracket to a Rack Post
Attach a Rail Assembly to a Front Bracket
1. Position a rail assembly (middle and outer rails) with its black plastic end caps toward the rear of the rack and its
outer rail closest to the brackets.
2. Align the front screw hole (Figure 24, C) in the outer rail (B) with the threaded hole (D) nearest the front of the
front bracket (A) and fit the rail assembly into the front and rear brackets.
3. Slide the middle rail toward the front (E) until the access hole (F) in the middle rail is aligned with the front
screw hole (C) in the outer rail.
4. Insert screw (G) through the access hole and loosely attach the outer rail to the front bracket.
5. In a similar manner to steps 2 through 4, install a screw through a slot in the outer rail and into the rear-most
threaded hole in the front bracket. Firmly tighten this screw.
6. Firmly tighten the front screw (G) installed loosely in step 4.
7. In the same manner, attach the other rail assembly to the other side.
A. #10-32 x
∫
-inch screw with washer
B. Nut bar
A
B