SUN EAST PEAK-350, Руководство пользователя

Страница: 16 / 74

SUN EAST PEAK-350
电脑波峰焊用户手册
15 -74
Air Pressure of Flux (Bar) 3~5
Soldering Angle
4
～
6
°
Finger Cleaning Pump
1
φ
220V 10W
Cooling fan
1
φ
220V 550W
2.4 Characteristics
1.
It characterized as newly streamline appearance, tight and nice-looking structure.
2.
It equipped with toughened glass door of hit mode, which can enlarge the inner room to
make it convenient for maintenance.
3.
The feed-in device is combined with the main conveyor so as to make the PCB can
enter into the conveyor smoothly and rightly.
4.
The inclination angle of lead rail can be adjusted through the dustproof screw with
simple structure, which can be locked by itself. So, the angle adjustment is laborsaving,
fast and precise.
5.
The width and height of feed-in entrance can be adjusted freely on basis of different
PCBs.
6.
The solder pot is made by titanium, which can be rot-proof. The solder pot adopts the
outer heat supply with even heaters. The volume of solder pot is small.
7.
The new type of nozzle applies to lead-free soldering techniques, which can make the
wave steady, smooth and with little oxide. The preheat system adopts PID analog
control, which can avoid the heavy shock of high voltage under the control of ON/OFF.
8.
The preheat system adopts the drawer structure for convenient maintenance. The
surface is made from the imported infrared ray thermal ceramic glass to lessen the heat
shock for evenly preheating.
9.
Exhaust fan for sprayer can be filtered for two times. The kettle for exhaust fan is for
exclusive use. The design of exhaust fan is for environmental protection.
10.
The newly sprayer adopts sealed structure. The flux can be supplied isobarically. The
movement is under the control of step motor and servo of closed loop. The noise is
small and the position is precise. The spray effect is good with even flux. Also, its
adjustment is convenient. The flux can be made full use and the sprayer is applicable to