Sumitomo Drive Technologies JVOP-182-H, Руководство по установке

Страница: 20 / 31

5 Installation Procedure
20
◆
Connecting the Option to the Unit
This section contains instructions for connecting the option to units.
■
Connecting the Option to HF-520
Plug the customer-supplied communication cable into the communication cable connector of
the option and the drive communications port as shown in Figure 8 . Ensure both cable ends
are firmly connected. Refer to Item Names and Part Numbers (Sold Separately) on page 11
for information regarding recommended cables.
Note: Use only Sumitomo recommended cables. Using a cable not specified may cause the option or
drive to malfunction.
Note: The STOP key on the built-in LED operator of the drive is the only functional key on the drive
when the option is connected and parameter b1-02 is set to 0. Set parameter o2-02 (STOP Key
Function Selection) to 0 (Disable) to disable the STOP key.
Figure 8
Figure 8 Communication Cable Connection
STOP
HF-520
(Hz)
(Hz)
(A)
(V)
:
:
:
:
:
:
:
:
:
: 周波数指令
正転逆転選択
出力周波数
出力電流
出力電圧
モニタ
ベリファイ
セットアップ
パラメータ設定
オートチューニング
据え付け、運転の前には必ず取扱説明書を読むこと。
通電中および電源遮断後
5
分以内はフロントカバーを
外さないこと。
400V
級インバータの場合は、電源の中性点が接地
されていることを確認すること。（ 対応）
けが、感電のおそれがあります。
危 険
Read manual before installing.
Wait 5 minutes for capacitor discharge after
disconnecting power supply.
To conform to requirements, make sure
to ground the supply neutral for 400V class.
Risk of electric shock.
WARNING
Option (JVOP-182-H)
Communication Cable Connector
Comm Port
Built-in LED
Operator
Drive