StoneAge PROPOSITIONER PROP-DBP, Руководство пользователя

Страница: 14 / 56

14
866-795-1586 • WWW.STONEAGETOOLS.COM
SUB-ASSEMBLY 1 (ABX-PRO, ROLLERS, COLLET BLOCK, AND GUIDE TUBE) SUB-ASSEMBLY 1 (ABX-PRO, ROLLERS, COLLET BLOCK, AND GUIDE TUBE)
SUB-ASSEMBLY 2 (LINEAR DRIVE HANDLE)
INSTALL THE COLLET BLOCK ASSEMBLY
1. Remove the Slide Block with a 6mm hex key. Rotate it so that
the end with the most distance from the screws is pointing
down. Align the holes in the Slide Block with the holes in the
Collet Block as shown in
(Figure 7).
Fasten with the two screws
that were removed.
2. Loosen the Collet Block Cap with a 1/4” hex key and slide the
Collet Block onto ABX-PRO Tractor Guide into the until it comes
to a stop. The Air Fittings on the ABX-PRO Tractor should be
opposite the Collet Block and the Slide Block should be on the
same side ABX-PRO label.
(Figure 8)
FIGURE 8
Collet Block
Cap
Air Fittings
ABX-PRO
Tractor Guide
1/4” Hex Key
FIGURE 7
Collet Block
Slide Block
Guide Tube
Orient as shown
Collet Block
FIGURE 9
Collet Block
Cap
INSTALL THE ANGLED GUIDE TUBE
3. Loosen the Collet Block Cap with a 1/4” hex key and slide
the Guide Tube into the Collet Block until it comes to a stop.
Orient the Guide Tube as shown in
(Figure 9) and tighten
the screws on the Collet Block Cap when the Guide Tube is
in place.
This side
down
Slide
Block
6mm Hex Key
1/4” Hex Key