Stinger HEIGH10
®
Installation & Integration Kit
for 2011-2018 Jeep
®
Wrangler JK
SRK-JK11H
© 2022 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
AAMP Global is not affiliated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms
OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identification purposes only. It is not
implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.
Pacific Accessory Corporation
Page 17
Rev: V1
Date:102722
®
Removing the Display Panel
Step 5
Step 3
Step 1
Step 2
While holding the display with
one hand, insert a soft plastic
panel tool under either bottom
corner and slightly pry up to
release the display panel.
Once the side clips are
disengaged, swing the bottom
edge upwards to unhook the top
of the frame and remove.
Remove the front frame by first
releasing the side clips at the
locations indicated by arrows.
Using a very thin pry tool or
similar, carefully release the side
clips as shown on both sides.
Step 4
Using a magnetic Phillips
screwdriver, remove the two
mounting screws on the left and
right sides of the mounting panel.
In the event the display panel needs to be removed, follow the instructions below to prevent damage to the
vehicle trim, radio display and installation kit.
