Stinger HEIGH10
®
Installation & Integration Kit
for 2011-2018 Jeep
®
Wrangler JK
SRK-JK11H
© 2022 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
AAMP Global is not affiliated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms
OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identification purposes only. It is not
implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.
Pacific Accessory Corporation
Page 10
Rev: V1
Date:102722
®
Part Three: Main Harness Connections (SRK-CH2A-HAR) (cont.)
Section 3: Display, Radio Module and Harness Preparation (cont.)
Slide the module bracket
assembly between the side
brackets on the radio module.
For each side, align the module
bracket with the two holes on the
side bracket. Using #6 coarse
thread screws from the HEIGH10
hardware, attached the module
bracket to the side brackets.
Step 7
Step 8
Step 11
Step 12
Step 10
From the HEIGH10 harnesses,
connect the 3-pin PAC-LINK
lead on the 10-pin Multi Camera
Harness to the PL1.
Route the 10-pin harness under
the radio module to the back of the
radio assembly.
From the HEIGH10 harnesses,
plug in the gray LVDS and black
8-pin display cable connectors into
the radio module.
On the SRK-CH1A-HAR Main
harness, plug the 16PIN Radio
harness and the 6PIN Steering
Wheel Control harness into the
HEIGH10 radio module.
Step 9
