Stinger HEIGH10
®
Installation & Integration Kit
for 2011-2018 Jeep
®
Wrangler JK
SRK-JK11H
© 2022 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
AAMP Global is not affiliated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms
OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identification purposes only. It is not
implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.
Pacific Accessory Corporation
Page 9
Rev: V1
Date:102722
®
Part Three: Main Harness Connections (SRK-CH2A-HAR)
Section 3: Display, Radio Module and Harness Preparation (cont.)
Step 1
Step 2
Using two of the longer 8” zip
ties, attach the CH1A-SRK to the
Module Bracket as shown. The
locking part of the zip ties should
be in the front, not the back.
Feed a 6” zip tie through the back
of the PL-1 and attach to the
bracket in the position shown.
Step 5
Step 3
Step 4
Secure the main harness to the
module bracket using a zip tie.
1
2
3
4
Connect the three connectors from
the SRK-CH2A-HAR Main Harness
to the indicated ports on the CH4
module.
Connect the fourth connector to the
appropriate port.
Amplified
(left) if
the vehicle has a factory amplifier,
Non-Amplified
(right) for base audio.
AMP
NON-AMP
Connect one end of the PAC 10P-2-
10P-6-HAR harness to either port
on the PL1. Connect the other end
of the harness to the Expansion Port
on the CHR1A-SRK module.
Step 6
