Stinger HEIGH10
®
Installation & Integration Kit
for 2011-2018 Jeep
®
Wrangler JK
SRK-JK11H
© 2022 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
AAMP Global is not affiliated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms
OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identification purposes only. It is not
implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.
Pacific Accessory Corporation
Page 11
Rev: V1
Date:102722
®
Part One: In-Vehicle Harness and Cable Connections
Section 4: Radio Unit Installation
Step 1
Step 2
Step 3
If just installing a single USB, plug
it into the USB port closest to the
edge of the radio. This port is for
Apple CarPlay and AndroidAuto.
Plug in the HDMI cable if installed.
If installing a second USB, plug it
into the other USB port on the radio
module.
Plug in the GPS antenna.
With the radio assembly inside
the vehicle, connect the AM/FM
antenna. Connect the vehicle’s
gray 22-pin radio plug to the
SRK-CH1A-HAR main harness.
Plug in the 10-pin radio harness
into the 10-pin port on the back of
the radio module.
When all connections are com-
plete, the two display cables
should be routed to the front of the
radio assembly and use a zip tie to
bundle the wire harnesses on the
rear of the radio module.
Connect the pink SPEED SEN lead
on the Main Harness to the pink
SPEED SEN lead on the 10-pin
Harness.
Step 13
Step 14
Step 15
Part Three: Main Harness Connections (SRK-CH2A-HAR) (cont.)
Section 3: Display, Radio Module and Harness Preparation (cont.)
X