Stinger HEIGH10
®
Installation & Integration Kit
for 2011-2018 Jeep
®
Wrangler JK
SRK-JK11H
© 2022 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
AAMP Global is not affiliated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms
OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identification purposes only. It is not
implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.
Pacific Accessory Corporation
Page 8
Rev: V1
Date:102722
®
Section 3: Display, Radio Module and Harness Preparation
Step 3
Step 2
Step 1
Partially screw in the four M4x10
screws from the SRK-JK11H
hardware into the side holes of the
mounting panel. NOTE: Ensure
screw tip is flush and does not
exceed the plastic thickness.
Use four M4x12 screws from the
HEIGH10 hardware to attach the
display to the mounting panel.
Place the HEIGH10 display into
the front of the mounting panel
and carefully turn the panel over
onto a soft surface while holding
the display in place.
Part One: Display Mounting Panel Preparation
Step 2
Step 3
Step 1
Using two M4x4 screws from the
HEIGH10 hardware, mount the
support bracket to the top of the
radio module in the location shown.
Align and attach one of metal side
brackets to the right side of the
radio module using two M5 x 10
screws from the HEIGH10 box.
Align and attach the remaining
metal side bracket to the left side
of the radio module using two M5 x
10 screws from the HEIGH10 box.
Part Two: Attaching the Radio Module Mounting Brackets
FRONT arrow should point
towards the Stinger logo.
