Still RX70-40, Оригинальное руководство пользователя

Страница: 196 / 392

4
Operation
Handling loads
NOTE
The shake function is only intended for short-
term use as it reduces the service life of the
load chains due to increased strain.
Operation
To activate the shake function:
– Move the corresponding operating device
for the "Lifting" function over the zero
position four times in quick succession.
The fork carriage moves as normal. The
shake function is active after the fourth time
the operating device is moved.
– Continue to move the operating device back
and forth.
The fork carriage moves up and down more
quickly and more jerkily.
The intensity of the shaking is controlled by
means of the intensity with which the operating
device is moved. The more fiercely the
operating device is moved, the more intense
the shaking is.
NOTE
After the function has been activated, the
driver has four seconds to start the shaking.
If the four seconds elapse without the shake
function being used, the shake function is
deactivated again.
WARNING
The shake function remains active for four seconds
following activation.
If the driver simply wants to raise or lower the
load during this time, it should be noted that the
fork carriage may move significantly more jerkily
with the load than in normal operation. If the four
seconds elapse without the shake function being
used, the fork carriage can be moved normally
again with the load.
The following section shows how the shake
function is activated via the standard assign-
ment for "lifting/lowering" using the different
variants of the operating devices. If the "Lift-
ing/lowering" function is assigned differently
184 57348011850 EN - 02/2019 - 11