2.
Note that F2 is etched with the word “FRONT” when installing F2 pay particular attention to the
orientation of this part.
Lay fuselage sides on a flat surface and gently work former F2 (“front” facing the nose
of the plane) into position. Next key F3 to assembly. Key FT1 spanning fuselage sides and formers. Square
parts to building surface and tack glue at each tab and notch location.
3.
Glue servo rails SR1 and SR2 inside fuselage assembly to underside of FT1 as indicated in the photo below.
4.
Install formers F4 and F5 (both 1/8” lite ply).
5.
Sheet forward section of fuselage with FB1 and FB2.
© 2004 Stevens AeroModel.
Page 9 of 31
