7.
Install the trailing edge cap strips TE2 and TE3, again these are notched to only fit on the top or bottom of the
trailing edge component TE1.
8.
Locate parts LG1, LG2, LG3, LG4, LG5, and LG6. Study the photo below and the plan sheet then dry fit the
parts as indicated in the photo below to create the main gear block. Next, fit the gear block to the wing center
section. Make certain your glue joints are thorough where the gear block meets R1.
9.
Install sub leading edge part LE3a to the notches along the front of the gear block. Next install, in this EXACT
order, LE3b then LE3c to the surface of LE3a. Make certain to align parts with the 1/8” locating dowel holes.
10. Install remaining leading edge parts LE2 as illustrated below:
© 2004 Stevens AeroModel.
Page 17 of 31
