Final Assembly
(continued)
83.
Remove the protective paper from the acetate windscreen in the kit. Bend the tab at the
base of the
center
portion of the windscreen
down,
to the approximate angle shown in the
side view of the fuselage, on the detail sheets.
84.
Fit the tab into the slot in the
upper
nose sheeting. Center the windscreen, and bond the
tab with a small drop of CA.
85.
Wrap the windscreen over the top of the wing and around the sides of the cockpit, holding it
in place with low-tack masking tape. When satisfied that the windscreen is in the correct
position, secure it with small drops of medium CA, applied sparingly.
86.
Propellor:
Mount the propellor (EFL9051) to the output shaft of the gear box. Grasp the
shaft with a small pair of needle nose pliers, and screw the propellor onto the threaded end
of the shaft.
Congratulations!
Your Stevens AeroModel
Clipped-Wing Taylorcraft
is now complete! Please proceed to the
Setup
and
Preflight
sections of these build instructions to prepare the model for flight.
Build Instructions
Clipped-Wing Taylorcraft
- Build Instructions © 2014 Stevens AeroModel, all rights reserved.
!
Page 32
□
□
□
□
