stertil-KONI Freedomlift SK 2055, Инструкция по установке и обслуживанию

Страница: 72 / 118

Installation and Service Manual 72 SK 2055 / 2070 / 2090
11.1 Emergency lowering
In an emergency where it is not possible to lower the vehicle lift from the control
box, the vehicle lift can be lowered manually.
The emergency lowering procedure must only be performed by persons who
are trained in this procedure.
11.2 Error messages
All malfunctions are indicated on the control panel.
• 30 mm elevation difference is indicated by a blinking control current LED (0.5
sec on, 0.5 sec off).
• Whenever the [UP] button is pressed, the vehicle lift should begin to rise
within 5 seconds. If it does not, then this is indicated by the LEDs in the
buttons [UP], [UNLOCK] and [DOWN] lighting up in succession. The 2x 7-
segment display on the control panel will then show error code 0 - 4.
• Errors can be recognised by the control current LED flashing (0.2 sec on,
0.8 sec off). If errors occur, the error code can be read on the 2 x 7-segment
display on the PCB.
The master post is the post with the main control box and hydraulic unit.
Error code Sticker Cause Solution
Slave Low Slave guide piece more
than 60 mm too low Vehicle lift blocked. Set the lift
horizontal using programme
code
65 (see Code 65 - Safe
limits on page 48).
Slave 15 mm high Slave guide piece 15 mm
higher than master guide
piece.
Control system corrects this
automatically during raising and
lowering.
Level within 15
mm
Slave and master within
15 mm of equal elevation.
Exact level Master and slave at
identical elevation.
Slave 15 mm low Slave guide piece 15 mm
lower than master guide
piece. Control system corrects this
automatically during raising and
lowering.